How to make a piston in MineCraft is pretty simple to do, but the big question is, how do you know where to place them correctly? Placing your piston correctly is crucial for it to work well enough. To make a piston in MineCraft, first go to the crafting table and put the following materials in the appropriate places on the 3×3 grid. For this part of the guide, I recommend that you use the simplest design possible. That way, your wooden planks fit neatly in the center row, your iron ingot is in the middle, and the red stone dust goes on the bottom row.
After you have placed all of your resources down: place a permanent magnet over each one of them, so that when the piston moves, the iron ingot or the wooden plank will not move with it. You should also make sure that the resource is attached to a support block between the two planks. This way, if your piston shifts, the resource would not shift as well. If you are using cobblestone or sandstone, this isn’t really necessary, but it can be handy if you have plans or levels that require this.
Once you have placed all of your resources down properly: place a permanent magnet over the middle of each of your three wood planks. This way, the iron ingot will not move with the piston because it is attached. Now, there is a trick to getting these pistons to work correctly. The easiest way is to break open all of your resource packs and look for the cobblestone and redstone dust. Place the small pieces over the iron ingot or wood plank in a row, creating a stable foundation for the piston.
Once you have done that: you should place the middle part of the metal piston between the two wooden planks. If you want, you can put a lever on the lever for extra leverage and tension. Then, you should place a lever on top of the first metal piston so that the first metal piston slips underneath the wooden planks. Place the last piece of wood on top of the first metal piston and that is it for your very own how to make a piston in minecraft!
In order to get your piston to work properly: you have to make sure that your settings are right. To find your settings, look at the piston scroll wheel and the piston control. You should notice that there is a tab for the wood planks at the bottom. Use this tab to customize your settings to the specifications of the scroll wheel. It is pretty easy, and all you have to do is stick your finger in between the 2 pieces of wood and then use your other hand to push down on both sides of the piston so that the tabs are guided into place.
That’s it! Your how to make a piston in minecraft craft has been made easier. Place your next craft here: the piston is waiting for you!